4-8 A-61408 September 1995

* Calibration Targets can be ordered from Kodak Parts Services. Targets come in a package of 5. Order Part #986527.

Error Code Description Action
E264 Call Target
Front Too Dark Tried to use a Calibration Target
where the front side is darker than
the specification required.
Press the Jog key to remove the
Calibration Target* from the transport
system. Use the appropriate
Calibration Target. Press Cal and try
the calibration process again.
E265 Cal Target
Rear Too Dark Tried to use a Calibration Target
where the rear side is darker than
the specification required.
Press the Jog key to remove the
Calibration Target* from the transport
system. Use the appropriate
Calibration Target. Press Cal and try
the calibration process again.
E278 Re-Scan–
Doc Feed Error A document has been fed which
is off-center or skewed. After pressing C, press Run to restart
the transport system.
E291 Scanner
Disabled The operator has tried to run the
transport system (other than via
the Count Only function) when the
scanner was disabled.
After pressing C, enable the scanner
from the host, then press Run.
E294 Fr Cal Fail
CalibrationReqrd A calibration failure was detected
in the Front Scan Module. After pressing C, press Cal to start the
calibration process again. If error
persists, verify the front optical path is
free of obstructions, clean the imaging
guides, and replace both the front and
rear (duplex scanners only) lamps.
E295 Rr Cal Fail
CalibraitonReqrd A calibration failure was detected
in the Rear Scan Module. After pressing C, press Cal to start the
calibration process again. If error
persists, verify the front optical path is
free of obstructions, clean the imaging
guides, and replace both the front and
rear (duplex scanners only) lamps.
E600
through
E699
various messages Follow the procedures indicated on the
display. If the error message remains,
turn the scanner off and then on again.
If the problem persists, call service.
E700
through
E799
various messages Follow the procedures indicated on the
display. If the error message remains,
turn the scanner off and then on again.
If the problem persists, call service.
E800
through
E899
various messages Follow the procedures indicated on the
display. If the error message remains,
turn the scanner off and then on again.
If the problem persists, call service.
E900
through
E999
various messages Follow the procedures indicated on the
display. If the error message remains,
turn the scanner off and then on again.
If the problem persists, call service.