A-61408 September 1995 4-7
* Calibration Targets can be ordered from Kodak Parts Services. Targets come in a package of 5. Order Part #986527.
Error Code Description Action
E241 Enter Cor-
rect IA, Re-Scan The patch document fed conflicts
with the level key pressed. After pressing C, verify the current
image level and image address and if
necessary alter the image level or
image address via the Level keys,
Next key or press Run and rescan the
patch document.
E244 Enter Cor-
rect IA, Re-Scan A T-patch document was fed then
followed by a 2-patch or 3-patch
document which conflicted with
the level of the T-Patch.
After pressing C, verify the current
image level and image address and if
necessary alter the image level or
image address via the Level keys,
Next key or press Run and rescan the
T-Patch, 2-patch or 3-patch document.
E245 Enter Cor-
rect IA, Re-Scan Two T-patch documents were fed
one right after the other. After pressing C, verify the current
image level and image address and if
necessary alter the image level or
image address via the Level keys or
Next key . Do not scan another T-
Patch document.
E246 Enter Cor-
rect IA, Re-Scan The T-Patch document fed
conflicts with the level of the
image address entered.
After pressing C, verify the current
image level and image address and if
necessary alter the image level or
image address via the Level keys,
Next key . Do not scan another T-
Patch.
E250 Frnt Illu-
mination Failure A front lamp failure was detected
while the front lamp was
illuminated.
Press Cal to initiate the calibration
process. If error persists, verify the
front optical path is free of
obstructions, clean the imaging
guides, and replace both the front and
rear (duplex scanners only) lamps.
E251 Rear Illu-
mination Failure A rear lamp failure was detected
while the rear lamp was
illuminated.
Press Cal to initiate the calibration
process. If error persists, verify the
front optical path is free of
obstructions, clean the imaging
guides, and replace both the front and
rear (duplex scanners only) lamps.
E261 Fr Cal Illu-
mination Failure A front lamp failure was detected
during the calibration process. Press the Jog key to remove the
Calibration Target from the transport
system. Press Cal and try the
calibration process again. If error
persists, verify the front optical path is
free of obstructions, clean the imaging
guides, and replace both the front and
rear (duplex scanners only) lamps.
E262 Rr Cal Illu-
mination Failure A rear lamp failure was detected
during the calibration process. Press the Jog key to remove the
Calibration Target from the transport
system. Press Cal and try the
calibration process again. If error
persists, verify the front optical path is
free of obstructions, clean the imaging
guides, and replace both the front and
rear (duplex scanners only) lamps.
E263 Calibration
Target Too Short Tried to use a Calibration Target
shorter than the specified 12
inches.
Press the Jog key to remove the
Calibration Target from the transport
system. Use the appropriate
Calibration Target*. Press Cal and try
the calibration process again.