3-12 A-61408 September 1995
Scanning Documents After you have prepared the scanner and your documents, you
are ready to begin scanning.
Automatic Feed Method 1. Make sure you select the correct scanning operation condi-
tions and values.
2. Place the feed shelf in the up position.
3. Pick up a stack of documents up to 1.5 inches (38 mm) thick.
Hold the stack with the front sides facing up and the top of the
documents facing toward the scanner. Tap the bottom edge of
the stack against a flat surface so the documents are in an
even bundle.
4. Fan the stack of documents so the leading edge of the top
document sticks out the farthest.
5. Make sure the power switch is on, then press Run.
6. Place the stack of documents into the feeder so the leading
edge of the first document meets the feed roller. Each docu-
ment will be drawn into the feeder, scanned, and deposited
face down in the exit hopper in the same order it entered the
feeder.
NOTE: Ensure the documents are center-fed so each document
covers the 2.5-inch required width as indicated by the
label on the feed tray.
A3
A5
11 X 17"
A4
2.5"
8.5 X 11"
Feed Tray Label
NOTE: The scanner is designed so each document automatically
gravitates into the feeder. Depending on the friction
between the documents, the automatic flow of the docu-
ments into the feeder may be inhibited. If the document
flow is inhibited, gently push the top document towards
the feeder to re-establish automatic feeding.