A-61408 September 1995 4-3

Message Listings
Error Code Description Action
E102 Press STOP
And Try Again Tried to use a function code that
is not valid while the transport
system is running.
After pressing C, press Stop to stop
the transport, then input the desired
code.
E103 Select
Valid Mode (1-18) Tried to use an invalid application
mode. After pressing C, enter function code
F01 and a valid application mode
number (1-18) to select another mode.
E104 Function
Not Available Tried to use an invalid function
code. After pressing C, press F and input a
valid function code. If this message is
displayed during scanning, the
message can be ignored. It will be
cleared at the end of scanning when
the Stop or End key is pressed.
E106 Doc Length
Monitor Warning Tried to scan a document which is
longer/shorter than the
maximum/minimum length which
has been set for the current
application mode.
After pressing C, check the document
length. If longer than actual, change
settings otherwise rescan.
E107 Doc Skew
Monitor Warning Tried to scan a document which is
skewed greater than the
maximum skew angle which has
been set for the current
application mode and less than 30
degrees.
Note the document that was skewed
and press C to clear the message.
Check self-centering feed tray.
E112 Invalid
Patch Level Tried to feed a patch document
that is invalid for the current
application mode. The patch
document is ignored and the
previous image level and image
address remain unchanged.
After pressing C, feed correct patch.
E113 Incorrect
Image Address Tried to use an invalid image
address for the current application
mode. The image address was
not completely input prior to
pressing Enter.
After pressing C, press Next to input
the correct image address.
E114 Check
Current IA/Level The operator pressed the Level
key and then fed a T-Patch
document. The Level key input is
ignored and the level defined by
the T-Patch of the current
application mode is assigned to
the next document.
After pressing C, verify the current
image level and image address.
E116 Accessory
Not Mode Enabled Tried to use an accessory that
has not been enabled. After pressing C, press F and enter a
different function code or select a
application mode that is enabled. If the
selected accessory is desired, service
must be called to change the mode
configuration.

When error codes are displayed, in most cases, you will need to

press the C key to clear the message. Then proceed with any

additional procedures as indicated in the Action column of the

following chart. If the error persists, contact your system

administrator.