Parameter Guide
D: HiEQGain |
Set the gain of the
Excessively raising the equalizer gain parameters may cause the output to be distorted.
■ARPEGGIATOR
These are the
Random
Notes will be played randomly.
Trigger
The notes that you are actually pressing will be sounded at intervals of the trigger. The trigger timing is determined by the “Tempo” setting.
The “Range” setting will be ignored.
Program parameters
Page25: ARPEGGIO
ON/OFF | [ON, OFF] |
Turn the arpeggiator on/off.
This parameter can be set only by the front panel key. When this is ON, the key LED will light.
LATCH | [ON, OFF] |
Specify how the arpeggiator will operate when you take your hand off of the keyboard.
This parameter can be set only by the front panel key.
If this is ON (the key LED will light), the arpeggiator will continue playing even if you take your hand off of the key- board.
If this is OFF (the key LED will go dark), the arpeggiator will stop playing when you take your hand off of the keyboard.
A: Type TYPE | [Up...Trigger] |
Select the arpeggio type.
Up
Notes will be played consecutively from low to high pitches.
Down
Notes will be played consecutively from high to low pitches.
Alt 1
Up and Down will be alternated. (The highest and lowest notes will be sounded once.)
Alt 2
Up and Down will be alternated. (The highest and lowest notes will be sounded twice.)
If a greater number of keys are played than the number of timbres specified in Page 01B: COMMON “Timbre Voice” or Page 03A: VOICE “Assign,” notes will be played starting at the
B: Range RANGE | [1 Octave...4 Octave] |
Specify the octave range in which the arpeggio will be played.
With a setting of 1 Octave, the arpeggio will be played in a range of 1 octave.
With a setting of 2 Octave, the arpeggio will be played in a range of 2 octaves.
With a setting of 3 Octave, the arpeggio will be played in a range of 3 octaves.
With a setting of 4 Octave, the arpeggio will be played in a range of 4 octaves.
C: Tempo TEMPO | [20...300] |
Specify the tempo of the arpeggio.
Increasing this value will speed up the arpeggio tempo.
If the Global mode Page 3C: MIDI “Clock” setting is External, this setting will be ignored.
This setting will also be the sequence playback speed.
D: Gate Time GATE | [000%...100%] |
Specify the note length (gate time) of the arpeggiated notes. With a setting of 000, each note will be extremely short. With set to 100, each note will continue playing until the next note is triggerd.
E: Target | [Both...Timbre 2] |
Select the timbre(s) that will be played by the arpeggiator. This parameter will be displayed and can be set only if Page 01A: COMMON “Mode” is set to Dual/Split.
Both
Both timbres will be sounded by the arpeggiator.
Timbre 1
Only timbre 1 will be sounded by the arpeggiator.
Timbre 2
Only timbre 2 will be sounded by the arpeggiator.
The MIDI channel of the timbre(s) to be sounded by the arpeggiator must be set to the Global MIDI chan- nel. If the timbre is set to other than the Global MIDI channel, it cannot be sounded by the arpeggiator.
45
