Korg MS2000R manual Page7 User Scale, Page8 Calib

		Parameter Guide
Arpegio		Move the connected pedal through its maximum range of
The pedal switch will function as an arpeggiator on/off		movement, and then press the [+/YES] key.
switch.
C: A.Switch	[–, +]	C: BW (MS2000 only)
		Set the active range of the MS2000’s pitch bender.
Select the polarity of the pedal switch that is connected.		Move the pitch bender through its maximum range of move-
Set this to “–” if you are using a Korg PS-1 pedal switch or if		ment, return it to the center, and then press the [+/YES] key.
you are not using a pedal switch.

D: A.SwMode [UnLatch, Latch]

Specify how a connected pedal switch will turn on/off. (With the factory settings, this is Unlatch.)

UnLatch

The switch will be on only while it is being pressed.

Latch

The switch will alternate between on and off each time it is pressed.

Page7: USER SCALE

A: User Scale

Specify the user scale.

For each pitch in the octave (C–B), you can adjust the pitch in a range of –100 — +100 cents.

The entire keyboard will use this scale if you set LCD Edit mode Page 01: COMMON “Scale” to User Scale.

7A USER SCALE

KEY[C ]:+000

Key	Detune
Key	[C...B]

Select the note whose pitch you wish to adjust.

Detune [–100...+100]

Adjust the pitch in one-cent units, relative to the equal tem- perament as 0.

A setting of +100 raises the pitch a semitone (+100 cents) above standard pitch.

A setting of –100lowers the pitch a semitone (–100 cents) below standard pitch.

D: MW (MS2000 only)

Set the active range of the MS2000’s modulation wheel. Move the modulation wheel through its maximum range of movement, and then press the [+/YES] key.

If you do not perform these settings correctly, the dis- play will indicate “Invalid Data” when you press the [+/YES] key. If this occurs, make the setting once again.

You must perform the Write operation for CALIB set- tings just as for other Global parameters. If you fail to perform the Write operation, the settings will revert to their previous values (☞p.30).

Global parameters

Page8: CALIB

Here you can set the active range of the MS2000/MS2000R’s controllers or a connected pedal switch or pedal. Make these settings if operating a controller or pedal does not produce the desired result.

A: AS

Make settings for a switch connected to the MS2000/ MS2000R.

Turn the connected switch on/off, and then press the [+/ YES] key.

B: AP

Set the active range of a pedal connected to the MS2000/ MS2000R.

57