Korg MS2000R manual Page06 Audio, Wave  Saw...Audio Control1  000 127 Control2 

	Parameter Guide
4. Vocoder Parameters	■ AUDIO IN 2
These are the parameters for a vocoder program (Page 01A:	These are the parameters for the input from the AUDIO IN 2
COMMON “Mode” = Vocoder).	jack.

parameters

■VOICE

Page03: VOICE

These parameters are the same as for Single synth programs. Refer to “3. SYNTH Parameters.”

■PITCH

Page04: PITCH

These parameters are the same as for synth programs. Refer to “3. SYNTH Parameters.”

■OSCILLATOR

Page05: OSC 1

A: Wave 		[Saw...Audio In]
B: Control1 		[000...	127]
C: Control2 		[000...	127]

Select the waveform of the carrier.

Saw, Pulse, Tri, VoxWave, DWGS, Noise, Audio In Refer to “3. SYNTH Parameters” Page 05: OSC 1.

Sin

A sine wave will be used. No cross modulation will be applied.

•Control1

Adjusting the value will modify the waveform.

•Control2

LFO1 will apply WFM (wave form modulation) to the waveform specified by “Control1.” The depth of the LFO1 modulation is adjusted by “Control2.”

Page06: AUDIO IN 2

A: Gate Sense [000...127]

Specify the speed of the gate that will be applied to the audio signal input from the AUDIO IN 2 jack according to the “Threshold” setting.

Lower values for this setting will make the gate operate more quickly, causing the vocoder sound to decay more quickly.

Higher values for this setting will make the gate operate more gradually, causing the vocoder sound to have a longer decay.

If the “Threshold” value is high, this effect will apply more readily. If the value is 0, there will be no effect.

B: Threshold   [000...127]

Specify the level at which the audio signal from the AUDIO IN 2 jack will be silenced.

Increasing this value will cause the audio signal to be silenced. This lets you eliminate any noise that might be heard when no input signal is present.

If this setting is set excessively high, the audio signal will also be cut, and it will be difficult for the vocoder effect to apply.

C: HPF Level   [000...127]

Adjust the amount of the high-frequency portion of the audio signal input from the AUDIO IN 2 jack that will be mixed into the output of the vocoder.

Increasing this value will emphasize the portion that corre- sponds to the consonants of speech or singing.

D: HPF Gate [ENA, DIS]

When mixing the high-frequency portion of the audio signal input from the AUDIO IN 2 jack into the output of the vocoder, this setting specifies whether this high-frequency portion will be output only while the internal tone generator is sounding, or whether it will always be output whenever there is an input to the AUDIO IN 2 jack.

ENA

Use this setting when you wish to apply the vocoder effect only to the internal tone generator, or when you wish to use the MS2000/MS2000R as a tone generator and connect the output of another synthesizer to the AUDIO IN 1 jack.

DIS

This setting is effective when you have connected a guitar via an effects unit etc. to the AUDIO IN 1 jack.

Program

49