Lexmark 90P3000, PRO4000C manual Printing on both sides of the paper duplexing, For Windows users

Printing 50

Warning—Potential Damage: Do not touch any open connector, the memory device, or the printer in the areas shown while actively printing, reading, or writing from the memory device. A loss of data can occur.

3If the PictBridge connection is successful, then the following message appears on the display: Use PictBridge

Device to choose and print photos. Press OK to select printer default settings.

4If you want to change the default print settings:

aPress OK to access the PictBridge menu.

bPress the arrow buttons to select the paper source, paper setup, photo size, number of photos per page and print quality. You can also enhance the quality of graphics. Press OK each time you make a selection.

Note: The printer will use the default print settings unless you change the print settings from the camera.

5See the documentation that came with the camera to begin printing.

Note: If you insert the USB cable of the PictBridge‑enabled camera while the printer is performing another job, then wait for the job to finish before printing from the camera.

Printing on both sides of the paper (duplexing)

Printing on both sides of the paper (duplexing) automatically

The automatic duplex unit supports A4‑, A5‑, letter‑, legal‑, statement‑, and executive‑size paper.

Notes:

•Other paper sizes may be supported.

•Two-sided printing is not supported on envelopes, card stock, or photo paper.

•Do not remove the page until printing is finished.

For Windows users

1With a document open, click File > Print.

2Click Properties, Preferences, Options, or Setup.

3Navigate to:

Layout tab > Print on Both Sides (Duplex) area > select Print on both sides

4Click OK to close any printer software dialogs.

5Click OK or Print.