NEC LC1400 manual Installing a 5.25-Inch Media Device

If you are adding or removing a SCSI removable media device, consider the following:

nThe optional SCSI tape drive address assignment is 2.

nThe SCSI termination resistors must be installed in the last SCSI drive of the daisy chain cabling. If the SCSI tape is your only SCSI device on the SCSI controller B, termination must be installed in the tape drive.

Installing a 5.25-Inch Media Device

CAUTION

CD-ROM devices contain a laser system and are classified as CLASS 1 LASER PRODUCTS. To use these devices, thoroughly read the documentation provided by the CD- ROM manufacturer, and keep the documentation for future reference. In case of any trouble with a CD-ROM, please contact your nearest service representative. To prevent direct exposure to the laser beam, do not try to open the enclosure. Use of controls or adjustments or performance of procedures other than those specified in the CD-ROM manufacturer's documentation may result in hazardous radiation exposure.

1.Power off the system, unplug the system power cord, and remove the appropriateside panel depending upon the bay you are installing the media device in and as described earlier in this chapter.

2.Open the front door as described earlier in this chapter.

CAUTION

Observe static precautions. Use an antistatic wrist strap.

3.Carefully remove the front system bezel by releasing its two plastic snap tabs on the back of the bezel and pulling it out (see Figure below).

4-30 Upgrading Your System