Replacing the SECC2 Version
1.Power off the system and remove the left side panel as described earlier in this chapter.
2.Pull the processor latches, Item A in Figure "Removing a Processor" below, out away from the edges of the SEC cartridge to free them from the Universal Retention Module (URM).
3.Lift the SEC cartridge upward, out of the URM and place it on a grounded,
Removing a Processor
4.Remove the barbed spring pins, Item A in Figure "Processor Heat Sink Assembly", below, that secures the heat sink to the old processor.
5.Remove the heat sink, Item B in Figure "Processor Heat Sink Assembly" below, from the front of the old processor, Item C in Figure "Processor Heat Sink Assembly" below.
6.Put the old processor in a piece of conductive foam and store in an antistatic package.
