10.Connect the interface and power cables to the device as follows (see Figure above):

n If you are installing a 5 1/4-inch tape drive or other IDE device, align and connect the drive signal cable and the system power cable to their connectors. The cable connector for the 5 1/4-inch device is keyed to fit only in the correct position. The red edge of the cable goes to pin 1 on the cable connector. Align the red edge of the connector with pin 1 (notched end) on the drive connector.

n If you are installing a SCSI device, connect the SCSI cable and system power cable. Be sure to align the SCSI cable connector (not keyed) with the device connector.

11.Carefully reinstall the front system bezel by inserting its top plastic tabs into the chassis top tab slots and then pushing its bottom portion straight in against the chassis (see Figure below).

12.Close the front door, reinstall the side panel, and power on the system.

Installing the Front System Bezel

4-34 Upgrading Your System

Page 114
Image 114
NEC LC1400 manual Installing the Front System Bezel Upgrading Your System