To change device configuration parameters, perform the following steps:
1.At the SCSI Configuration Utility Main Menu, select the adapter which connects to the SCSI device you are reconfiguring. The first adapter listed controls the operation of the hard disk drives; the second adapter controls any SCSI removable media devices installed in your system. Press ENTER.
2.Select “Device Selections” and press ENTER. The Devices 0 to 7 screen displays.
3.Select the SCSI device you are reconfiguring and press ENTER. If you are configuring SCSI Hard Disk Drives, refer to the SYM53C875 Adapter 1 Table below; if you are configuring SCSI Removable Media Devices, refer to the SYM53C875 Adapter 2 Table below for recommended settings.
SYM53C875 Adapter 1 – SCSI Hard Disk Drives
Description | Recommended Setting or | Your Configuration |
| Display Only |
|
|
|
|
Device Selections | Dev0 | Dev1 Dev2 Dev3 |
Press ENTER for menu. |
| |
| Select device and press |
|
| ENTER. |
|
Sync Rate | 40 |
|
Width (bits) | 16 |
|
Disconnect | On |
|
Read/Write I/O timeout | 10 |
|
(secs) |
|
|
Scan for device at boot time | Yes |
|
Scan for SCSI LUNS | No |
|
Queue Tags | On |
|
|
|
|
