5.Disconnect the power cable (A) and ribbon data cable (B) from the device you are removing.
Removing a Removable Media Device
6.Remove the device from the peripheral bay by pushing in on its drive rail clips and pull the device completely out of the bay (see Figure above).
7.Install an EMI metal shield over the bay where you removed the peripheral device. The EMI shield is secured by just snapping it into place.
8.Install a filler panel in the open area of the system bezel corresponding to the bay where the media device was removed.
9.Replace the side panel and front panel, and power on the system.
10.Remove the drive serial number from the equipment log.
