NEC LC1400 manual Message Description, Setup

	BIOS Messages (Continued)
Message	Description
Parity Check 1 nnnn*	A parity error was found in the system bus (Parity
or	Check 1) or the I/O bus (Parity Check 2). BIOS
Parity Check 2 nnnn*	attempts to locate and display the address on the
	screen. If it cannot locate the address, it displays.
Press <F1> to resume, <F2> to Setup	Displayed after any recoverable error message.
Press <F2> to enter SETUP	Optional message displayed during POST. Can be
	turned off in Setup.
Previous boot incomplete - Default	Previous POST did not successfully complete. POST
configuration used	loads default values and offers to run Setup. If the
	failure was caused by incorrect values and they are not
	corrected, the next boot will likely fail. On systems with
	control of wait states, improper Setup settings can also
	terminate POST and cause this error on the next boot.
	Run Setup and verify that the wait-state configuration is
	correct. This error is cleared the next time the system is
	booted.
Real time clock error*	Real time clock fails BIOS test. May require board
	repair.
Shadow Ram Failed at offset: nnnn*	Shadow RAM failed at offset nnnn of the 64K block at
	which the error was detected.
nnnn Shadow RAM Passed	Where nnnn is the amount of shadow RAM in kilobytes
	successfully tested.
System battery is dead - Replace and	The CMOS clock battery indicator shows the battery is
run SETUP	dead. Replace the battery and run Setup to reconfigure
	the system.
System BIOS shadowed	The system BIOS is copied to shadow RAM.
System cache error - Cache disabled*	The RAM cache failed the BIOS test and BIOS has
	disabled the cache.
System CMOS checksum bad - run	The system CMOS has been corrupted or incorrectly
SETUP	modified, perhaps by an application program that
	changes data stored in CMOS. Run Setup and
	reconfigure the system either by getting the default
	values or making your own selections.
System RAM failed at offset: nnnn*	The system RAM failed at offset nnnn of the 64K block
	at which the error was detected.
nnnn System RAM Passed	Where nnnn is the amount of system RAM in kilobytes
	successfully tested.

5-18 Problem Solving