Northern UTA220/UTA220k manual Default 1,1,0

AT Command Set

Table C-1: UTA 220 AT Command Set (Continued)

Command	Description		Value
%L4=	Selection of Idle Timer	Range: 0-255default (0,0,20)
	Delay
%L5=	Ancillary Device Control	0	Off
		1	On in data transfer
		2	On in data transfer and com-
		mand
		default (1,1,0)
%L6=	Control of PAD Service	0	Suppressed
	Signals	1	All but prompt in standard for-
		mat
		5	All
		default (0,1,0)
%L7=	Action on receipt of break	0	None
	signal from DTE	1	Send an interrupt packet
		2	Send a reset packet
		5	Send interrupt and indication
		of	break packets
		8	Escape from data state
		21	Send interrupt and indication
		of	break packets and set %L8 to
		1
		default (5,2,2)
%L8=	Discard output to DTE	0	Normal Data Delivery
		1	Discard output to DTE
		default (0,0,0)
%L9=	Padding after carriage	Range: 0-255default (0,0,0)
	return
%L10=	Line Folding	Range: 0-255default (0,0,0)
%L11=	DTE Speed	2	300
		3	1200
		4	600
		12	2400
		13	4800
		14	9600
		15	19200
		16	38400
		default (16,16,16)
%L12=	Flow Control of the PAD	0	Off
		1	Use \Q
		default (0,1,0)

*Note: "by port" indicates that these switch parameters are associated with a particular port. However, this does not exclude ports from sharing the same SPID or TEI.+

C-12 UTA220/UTA220k