Northern UTA220/UTA220k manual Dle, Esc,Bel,Enq,Ack, Nak

			AT Command Set
	Table C-1: UTA 220 AT Command Set (Continued)
Command	Description		Value
%B19=	Transmit Delay	Range: 1-65535default (0)
			units = ms
%B20=	Reset Notice	0	Normal operation <default>
			(write only 0)
		1	DTE originated
		2	Local procedure error
		3	Incompatible destination
		4	Network congestion
		5	Remote procedure error
		6	Reset cause unknown
		Not saved in non-volatile. User may
		clear. TA updates to normal at the
		beginning of X.25 call.
%B99=	Packet Reset, Clear,	Range: 0-600 default (180)
	Restart Timer
%B98=	Packet Call Timer	Range: 0-600 default (180)
%B97=	Auto Accept Virtual Call	E	Enabled<default>
		D	Disabled
	Session Parameters: X.3 PAD
%L1=	PAD Recall Using a	0	None
	Character	1	DLE
		32-126
		default	(0,1,0)
%L2=	Echo	0	No echo
		1	Echo
		default	(0,1,0)
%L3=	Selection of Data Forward-	0	None
	ing Characters	1	A-Z, a-z, 0-9
		2	<CR>
		4
		<ESC>,<BEL>,<ENQ>,<ACK>
		8	<DEL>, <CAN>, <DC2>
		16	<ETX>, <EOT>
		32	<HT>, <LF>, <VT>, <FF>
		64	<NUL>, <SOH>, <STX>,
		<BS>,	<SO>, <SI>, <DLE>, <DC1>,
		<NAK>	<DC2>,<DC3>,<DC4>,
			<SYN>, <ETB>, <EM>,
		<SUB>,
			<FS>, <GS>, <RS>, <US>
		default	(0,126,0)
*Note: "by port" indicates that these switch parameters are associated with a
particular port. However, this does not exclude ports from sharing the same
SPID or TEI.+

UTA220/UTA220k C-11