FCC REQUIREMENTS
WARNING
This equipment uses, generates, and can radiate radio frequency energy interfering with radio communications if not installed and used according to the instruction manual. It has been tested and complies with the limits for a Class A computing device according to FCC Rules, Part
15.Operation of this equipment in a residential area may cause interference. If it does, you must correct the cause of the interference.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
SHIELDED CABLES
Shielded DTE cables should be used with this unit to ensure compliance with Class A limits.
SPECIAL REQUIREMENTS FOR CANADA
Certain requirements exist for data communication products manufactured for use in Canada. Principle among these requirements is the application of the IC stamp as described below. However, certain data communication products do not require the IC stamp nor adherence to IC requirements. If this is the case the IC stamp will not be affixed to the rear panel of standalone units nor packaged with units designed for insertion in user equipment.
Industry Canada (IC) Requirements
IC stamps are affixed to the rear of each standalone unit sold in Canada. Card units which are installed in the user’s equipment are shipped with a stamp included. The user should place the stamp on the outside of his equipment as close as possible to the telephone line connector. This stamp has the certification number for that particular unit. The numbers are different for each model.
The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational, and safety requirements. IC does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the company’s inside wiring associated with a single line individual service may be extended by means of a certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.
iii
