Northern UTA220/UTA220k manual One default

				AT Command Set
	Table C-1: UTA 220 AT Command Set (Continued)
Command	Description			Value
@P6=	Number of Stop Bits	0	One <default>
		1	One and One-Half
		2	Two
	Port Commands: Action
A	Answer
D	Dial	S = n		Dial stored Number n
		0-9,#,*		Digits
		;		Return to on-line
		command mode
		(ATO dial)s
		P,T,W		Ignored
H	Hangup
In	Information	n =	0	Product ID ("960")
			1	ROM Checksum
			2	Checksum
		Verification
			3	Revision
		("4563672-1NRPT3 C34A PASS")
			<board#>-<software>
			<checksum> <PASS/FAIL>
I4	Numeric Capability String
I8	Verbose Capability String
I9	Plug-and-Play ID
I10	ISDN Link Status
I11	Port Status
I12	User-definable Device ID
On	Return On-Line	n =	0	Return On-Line
			1	Return On-Line
Zn	Reload Port from	n = 0, 1
	non-volatile set n
&Fp	Load Port from factory	p = 0, 1
	profile p
*Note: "by port" indicates that these switch parameters are associated with a
particular port. However, this does not exclude ports from sharing the same
SPID or TEI.+

UTA220/UTA220k C-7