Northern UTA220/UTA220k manual Rpoa, Call

AT Command Set

Table C-1: UTA 220 AT Command Set (Continued)

Command	Description		Value
%B12=	Transmit Through Input	0	Use network default
	Class	<default>
		1	Reserved
		2	Reserved
		3	75
		4	110
		5	300
		6	600
		7	1200
		8	2400
		9	4800
		10	9600
		11	19200
		12	48000
		13	64000
		14	Reserved
		15	Reserved
%B13=	Network User ID	Range: 0-16 characters
			default (null string)
%B14=	RPOA	Range: 0-16 characters
			default (null string)
%B15=	Called Line Address	0	Call not redirected <default>
	Modification Code (Caller,	1	Called station was busy
	Read Only)	7	Call distribution within a hunt
			group
		9	Called station was out of or-
		der
		15	Systematic call redirection by
			called station
		Not saved in non-volatile. Initialized
		to factory defaults before each virtual
		call.
%B16=	Called Redirection	0	Call not redirected <default>
	Notification Code (Called,	1	Called station was busy
	Read Only)	9	Called station was out of or-
		der
		15	Systematic call redirection by
			called station
		Not saved in non-volatile. Initialized
		to factory defaults before each virtual
		call.
%B17=	Intended Call Address	Range: 0-15 digitsdefault (null
		string)
%B18=	User Data	Range: 0-12 characters
			default (null string)

*Note: "by port" indicates that these switch parameters are associated with a particular port. However, this does not exclude ports from sharing the same SPID or TEI.+

C-10 UTA220/UTA220k