Northern UTA220/UTA220k manual Off default

AT Command Set

Table C-1: UTA 220 AT Command Set (Continued)

Command	Description		Value
%A4=	Line Channel Speed	0	64 kbps <default>
		1	56 kbps
%A96=	Echo Disable Tone	0	Off <default>
		1	On
%A97=	Dialing Method	O	Overlap
		E	Enbloc <default>
%A98=	Originate Mode	N	Normal <default>
		V	Voice
%A99=	Answer Mode	N	Normal <default>
		V	Voice
@G=	DTE Guard Mode	D	Disabled <default>
		E	Enabled
@P1=	Dialer Commands	N	None
		A	AT <default>
		VB	V25bis BYSYNC
		VH	V25bis HDLC
		E	EIA-366
@P2=	DTE Speed	Note: Speed can be entered as a
		code or a bit rate. The bit rate value
		displays.
		3	300
		5	1200
		6	2400
		7	4800
		9	9600
		12	19200
		13	38400 <default>
		32	48000*
		17	56000*
		18	57600*
		19	64000*
		20	112000*
		22	115200*
		21	128000*
		* disables Autobaud
@P3=	Parity	N	None
		O	Odd
		E	Even <default>
		M	Mark
@P4=	Number of Data Bits	Range: 7-8<default is 8>

*Note: "by port" indicates that these switch parameters are associated with a particular port. However, this does not exclude ports from sharing the same SPID or TEI.+

C-6 UTA220/UTA220k