3 SafeCom Controller

3.4.5Assign a fixed IP address to the SafeCom Controller

The IP address can be assigned via DHCP (dynamic or fixed) or manually. The steps below describe how to assign a fixed IP address via the SafeCom Controller web interface.

1.Open the Advanced Configuration web page (3.3.2).

2.Click TCP/IP.

3.Check Manual and enter the IP address etc.

4.Click Save and Continue.

5.Click Restart.

3.4.6Select user identification

1.Open the Advanced Configuration web page (3.3.2).

2.Click SafeCom. Change Front End Identification.

3.Click Save and Continue to save your settings.

4.Select Restart. Click Restart again.

You must wait approx. 1 minute while SafeCom initializes. If the control panel on the Sharp MFP does not reflect the change in the login screen then refresh the screen by pressing the JOB STATUS button on the Sharp MFP and then the COPY button.

3.4.7Disable the Test button

To prevent unauthorized users from restoring factory default you can disable the SafeCom Controller’s test button.

1.Open the Advanced Configuration web page (3.3.2).

2.Click General.

3.Change Enable Test Button to NO.

4.Click Save and Continue.

Click Restart.

3.4.8Enable Copy Control

1.Open the Advanced Configuration web page (3.3.2).

2.Click Printer and change Copy Enabled to YES and change Use auto configuration to YES.

3.Click Save and Continue.

4.Click Restart.

D60709-22

46

Page 46
Image 46
Nuance comm D60709-22 Assign a fixed IP address to the SafeCom Controller, Select user identification, Enable Copy Control