4100 Fax ENGLISH 15/1/97 9:37 am Page 48
English
04IMAGE IN MCF: When a message confirmation is printed, this function adds a portion of the first page your fax machine transmitted. This is printed at the bottom of the message confirmation report. Available settings are on and off.
05SENDER ID: This function controls the printing of your fax machine’s Sender ID on the faxes you send. When turned on, your fax machine’s Sender ID will be printed on each page slightly outside the image area of your document. When turned off, your fax machine’s Sender ID will not be printed.
06MONITOR VOLUME: This function sets the vol- ume your fax machine uses for telephone line moni- toring sounds during dialling. Available settings are low, high and off.
07BUZZER VOLUME: This function sets the vol- ume of the various beep and alarm tones your fax machine emits during operations. Available settings are low, middle and high.
08CLOSED NETWORK: This function allows you to program your fax machine to refuse to receive faxes from or transmit faxes to locations whose tele- phone numbers have not been programmed into your fax machine’s One Touch keys or Auto Dial numbers. Using this function, you can set up a closed network of fax machines. If you do not want your fax machine to transmit faxes to or receive
48Programming
faxes from locations outside your network, select T/R. If you only want your fax machine to refuse to receive faxes from outside your network, select RX. Available settings are OFF, T/R and RX.
09TX MODE DEFAULT: This function allows you to change your fax machine’s default type of original and transmit resolution settings. Unless you select otherwise using the Transmit Resolution/Yes ◀ or Type of Original/No ♣ keys, your fax machine is set to use the STD and NORMAL settings. If you are constantly sending faxes which require some other combination of transmission modes, use this function setting to change the default transmission modes to any other combination of settings. While you are programming, the new default combinations will appear on the LEDs above the Transmit Resolution/Yes ◀ or Type of Original/No ♣ keys.
10T/F TIMER PROG.: When set to the telephone/ fax answering mode, your fax machine automatically distinguishes between incoming voice and fax calls. If the incoming call is a voice call, your fax machine will ring to tell you to pick up the handset. If you do not answer, your fax machine automatically switches back to facsimile mode to allow the calling party to send a fax. The T/F TIMER function controls how long your fax machine waits before switching back to fax mode. Available settings are 20 seconds or 35 seconds.
