Oki manual Oki B6100 User Guide Testing the Envelope Feeder

Oki B6100 User Guide

Testing the Envelope Feeder

8-7

Testing the Envelope Feeder

After installing the envelope feeder, use the following test procedure to verify that the feeder is operating correctly.

1.Turn the printer on by pressing the [ I ] on the power switch on the right side of the printer.

2.Once the printer has warmed up and displays the “Ready” message on the control panel display, use any software application to print a few sheets from the envelope feeder.

NOTE: The printer automatically recognizes an option after the option is installed. The printer driver does not. You must enable (activate) the option in the printer driver after the option is installed.

The steps you will follow vary according to both your operating system and your installed printer driver. Here are the general steps you will follow.

Select the driver you want to work with.

Locate the printer properties section within the printer driver. Use the pulldown window to select the option.

Activate the option.

3.If the feeder does not feed paper or if the control panel displays an error message, refer to“Solving Envelope Feeder Problems” on page 8-12.

Oct 02