Oki 6100 manual System Menu, Display Language, Power Saver, Wait Timeout

Oki B6100 User Guide

System Menu

3-17

System Menu

NOTE: Settings in your software application will override any settings in your printer driver.

Your printer driver settings will override any settings from the printer menu or printer front panel.

The system menu provides access to system settings. Use the following procedure to enter the system menu:

1.Press the MENU button on the control panel.

2.Press the NEXT button until the text “System Menu” is shown on the second line of the display.

3.Press the SELECT button to enter the system menu.

4.Press the NEXT button to move through the submenus: Factory Defaults, Display Lan- guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, and Hex Print.

5.Press the SELECT button to enter a submenu.

6.Use the procedures in the following table to access and change the system settings:

Submenus	Default Setting	Available Settings	Procedure for Changing Setting
Factory Defaults	U.S.	U.S.	1.	Press NEXT or PREVIOUS to
This submenu allows you to reset the		Non-U.S.		toggles between U.S. and NON-U.S.
printer to U.S. or Non-U.S. factory			2.	Press SELECT to choose and set the
defaults.				factory defaults.
Display Language	English	English	1.	Press NEXT or PREVIOUS to scroll
This submenu allows you to change		French		through the available languages:
the language of the display messages.		German		English, French (Francais), German
		Italian		(Deutsch), Italian (Italiano), or
		Spanish		Spanish (Espanol).
			2.	Press SELECT to choose and set the
				language.
Power Saver	15	0 - 999	1.	Press NEXT or PREVIOUS to
This submenu allows you to set the				increase or decrease the number of
number of minutes the printer is idle				minutes.
before it reverts to Power Saver			2.	Press SELECT to save this setting.
Mode.
Wait Timeout	20	0 - 99999	1.	Press NEXT or PREVIOUS to
This submenu allows you to increase				increase or decrease each digit of the
or decrease the length of time (in				five-digit number.
seconds) that the printer will remain			2.	Press SELECT set one digit and
in the waiting state—a job is being				move to the next digit.
processed, no end-of-file has been			3.	Press SELECT after changing the last
detected, and there is no more data to				digit to save this setting.
process. This setting applies to both
PCL and PostScript print jobs.

Oct 02