
Oki B6100 User Guide
Installation Problems
Inoperative Printer
If you have problems turning on the printer, check the possible causes listed in the table below. If the printer will not start after checking these items, turn the printer off, disconnect the power cord from the AC outlet, and contact your dealer or an authorized service provider.
Description | Possible Cause | Action |
|
|
|
There is no power. | The power switch is not set to | Check the power switch. Refer to the |
| [ I ] (on). | Installation Guide. |
|
|
|
| The power cord is not properly | Set the power switch to [ O ] (off) and then |
| plugged into an AC outlet or | connect the power cord firmly to the AC |
| into the AC connector on the | connector and to the AC outlet. |
| rear of the printer. | Refer to the Installation Guide. |
|
|
|
| Voltage of the AC power is not | Verify that the AC outlet is rated for the voltage |
| correct. | of your printer. |
|
|
|
| The fuse on the power cord is | Verify that the fuse on the power cord is intact. |
| not functioning. (UK only) | (UK only) |
|
|
|
| The AC wall outlet is not | Verify that voltage is present at the AC wall |
| functioning. | outlet by connecting another electrical device |
|
| to the outlet. If power does not flow to the other |
|
| device, check the AC wall outlet circuit |
|
| breakers for a tripped breaker. |
|
|
|
| There is interference from other | Unplug all electrical devices from the AC wall |
| electrical devices on the same | outlet circuit, and then reconnect only the |
| circuit. | printer. Turn printer power on. |
|
|
|
| Thermal sensors may have shut | Turn the printer off and wait 20 minutes, then |
| down the printer. | turn the printer back on. |
|
|
|
Power is frequently | The printer is malfunctioning. | Turn the printer off and disconnect the power |
interrupted. |
| cord from the AC outlet. Contact your dealer or |
|
| an authorized service provider. |
|
|
|
No Ready Message
After warming up, the printer control panel displays the text “Ready,” indicating that the printer is ready to print. If the printer does not show this message, but shows an error message instead, refer to “Warning Messages and Error Messages” on page