Panasonic AJ-B95 manual 43

Setup menus

TIME CODE menu

	Item		Setting		V	V
				Description of setting	T	T
	Superimposed		Superimposed
No.		No.			R	R
	display		display		1	2
571	TC JUMP			This selects the setting for TC jumping.
		0000	OFF	0: No TC jumping.
		0001	VTR1	1: TC jumping on the VTR1 side only.
		0002	VTR2	2: TC jumping on the VTR2 side only.
		0003	ALL	3: TC jumping on both the VTR1 and VTR2 sides.
				<Note>		[
				During TC jumping, the tape is cued up to the IN point and then,
				using the CTL value of the IN point as a reference, the tape is
				prerolled or run up.
				When edit recording mode is initiated after the IN point has been
				passed through, the unit switches to the TC reference.
572	V-MON/TC OUT			This selects whether the video monitor output connector is to be
				used as the TC output connector.
				When it is to be used as the TC output connector, whether the
				phase of the TC signal which is output in the E-E mode is to be
				aligned with the video output or input TC is also selected.
		0000	V-MON	0: The connector is used as the video monitor output connector.
		0001	TCOUT1	1: The connector is used as the TC output connector, and in the	[	[
				E-E mode the output TC signal phase is aligned with the input
				TC signals.
		0002	TCOUT2	2: The connector is used as the TC output connector, and in the
				E-E mode the output TC signal phase is aligned with the output
				video signals.
				<Note>
				The TCOUT2 can be set only on the VTR2 side.
573	TC PRESET			This selects the time code value of the internal TCG.
				00:00:00:00 to 23:59:59:29 (525i mode)	[	[
				00:00:00:00 to 23:59:59:24 (625i mode)
574	UB PRESET			This selects the user’s bit value of the internal TCG.	[	[
				00:00:00:00 to FF:FF:FF:FF

The underlining indicates the factory setting.

43