Set the IN point and OUT point of the voice-over positions.
Press the PREVIEW button to execute preview.

Voice-over operations (2)

Voice-over can also be performed by taking the steps below.

Steps 1 through 7 are the same as for voice-over operations (1).

1

Select “INT_VO” as the setup menu item No.317

 

(AUD MEM MODE) setting.

 

“m” now appears on the superimposed display

 

of VTR2. (See page 85)

2

Select the channel (CH1, CH2) on which the

 

sound is to be recorded with the setup menu

 

item No.318 (AUD MEM CH) setting.

3

Connect the audio signals which are to be

 

recorded.

 

When connecting a microphone, connect it to

 

CH2 on the VTR2 side (the second AUDIO IN

 

connector from the left as seen from the rear

 

panel).

4

Set the VTR2 AUDIO INPUT selector switch

 

(ANALOG/SDI/INT) for the channel on which the

 

sound is to be recorded to the ANALOG

 

position.

5

Set the VTR2 AUDIO INPUT selector switch

 

(channel selector) for the channel on which the

 

sound is to be recorded to the audio signal input

 

channel.

6

Insert the voice-over cassette tape into VTR2.

7

Press the insert buttons (A1, A2) for the channel

 

on which the sound is to be recorded to turn on

their lamps.

8

9

10 Input the sound to be recorded (from the microphone, etc.) between the IN point and OUT point during preview.

The input sound is now stored in the internal memory.

Twenty seconds after this information is written into the internal memory, “o” appears on the superimposed display to indicate that the memory is now full. (See page 85)

11 Press the AUTO EDIT button to execute editing. The sound stored in the memory is now recorded on the tape.

65