Panasonic KX-FC228HK operating instructions Error messages - Reports, Help

11. Help

11.1 Error messages – Reports

If a problem occurs during fax transmission or reception, one of the following messages will be printed on the sending and journal reports (page 29).

Message	Code	Cause & Solution
COMMUNICATION ERROR	40-42	L A transmission or reception error occurred. Try
	46-72	again or check with the other party.
	FF
	43	L A line problem occurred. Connect the telephone line
	44	cord to a different jack and try again.
		L An overseas transmission error occurred. Try using
		the overseas mode (feature #23 on page 46).
DOCUMENT JAMMED	-----	L Remove the jammed document (page 71).
ERROR-NOT YOUR UNIT	53	L A transmission or reception error occurred because
	54	of a problem with the other party’s fax machine.
	59	Check with the other party.
	70
JUNK FAX PROH. REJECT	-----	L The junk fax prohibitor feature of this unit rejected
		fax reception.
MEMORY FULL	-----	L The memory is full of received documents due to a
		lack of recording paper, a lack of ink film or a
		recording paper jam. Install paper (page 13), install
		ink film (page 11) or remove the jammed paper
		(page 70).
NO DOCUMENT	-----	L The document was not fed into the unit properly. Re-
		insert the document and try again.
OTHER FAX NOT RESPONDING	-----	L The other party’s fax machine is busy or has run out
		of recording paper. Try again.
		L The other party’s fax machine rang too many times.
		Send the fax manually (page 29).
		L The other party’s machine is not a fax machine.
		Check with the other party.
		L The number you dialled is not in service.
PRESSED THE STOP KEY	-----	L {STOP} was pressed, and fax transmission or
		reception was cancelled.
OK	-----	L Fax transmission or reception was successful.

60