Panasonic PT-DW100U Gamma setting, Adjusting the picture, Press to switch Color Temperature

Adjusting the picture (continued)

3.Press ◄► to switch “COLOR TEMPERATURE”.

•The setting will change as follows each time ◄► is pressed.

DEFAULT USER1 USER2

HIGH MIDDLE LOW

•When any setting other than “OFF” has been selected for color matching, the COLOR TEMPERATURE setting is fixed at “USER1”.

•“DEFAULT” cannot be selected when the picture mode has been set to “USER”.

„To further adjust toward the desired white balance

4.Select “USER1” or “USER2” in Step 3.

5.Press ENTER.

•The “WHITE BALANCE” screen will be displayed.

WHITE BALANCE

WHITE BALANCE HIGH

WHITE BALANCE LOW

6.Press ▲▼ to select “WHITE BALANCE HIGH” or “WHITE BALANCE LOW”.

7.Press ENTER.

•The “WHITE BALANCE HIGH” RGB settings are used to set the projector’s white point color temperature. The “WHITE BALANCE LOW” RGB settings are used to adjust the color temperature of the black levels.

WHITE BALANCE HIGH

RED	255
GREEN	255

8.Press ▲▼ to select “RED”, “GREEN” or “BLUE”.

9.Press ◄► to adjust the level.

Note

•All colors will not be displayed properly unless adequate adjustment is made. If the adjustment does not look suitable, you can press DEFAULT to return the setting for the selected item only to the factory default setting.

•The color temperature cannot be adjusted for the internal test pattern (p. 85). Be sure to project the input signal when adjusting the color temperature.

Gamma setting

This switches the gamma mode.

1. Press ▲▼ to select “GAMMA”.

COLOR TEMPERATURE	DEFAULT
GAMMA	DEFAULT
SHARPNESS	0

2.Press ◄► or ENTER.

•The “GAMMA” individual adjustment screen will be displayed.

GAMMA DEFAULT

CHANGE

3.Press ◄► to switch “GAMMA”.

•The setting will change as follows each time ◄► is pressed.

DEFAULT USER1* USER2*

2.6 2.5 2.2

*“USER1” and “USER2” can hold user-defined gamma curves uploaded to the projector through the RS-232 terminal.

Additional Gamma settings can be made available for selection from a sub-menu.

Consult your dealer for more information.

Note

•“DEFAULT” cannot be selected when the picture mode has been set to “USER”.

Item	Operation	Adjustment	Adjustment
			range
	Press ►	Deepens red.	Maximum
RED	button.		value
	Press ◄	Weakens red.	HIGH : 255
			LOW : 127
	button.
	Press ►	Deepens green.	Minimum
GREEN	button.		value
	Press ◄
		Weakens green.	HIGH : 0
	button.		LOW : -127
	Press ►	Deepens blue.
			Default
BLUE	button.
	Press ◄	Weakens blue.	HIGH : 255
			LOW : 0
	button.

54 – ENGLISH