
Projector setup (continued)
Load all user data
This loads various setting values that were saved as a backup to the internal memory of the projector.
1. Press ▲▼ to select “LOAD ALL USER DATA”.
SAVE ALL USER DATA
LOAD ALL USER DATA
INITIALIZE
2.Press ENTER.
•The “SECURITY PASSWORD” screen will be displayed.
SECURITY PASSWORD
3.Enter the password set for the security password of the
security menu.
• A confirmation screen will appear.
LOAD ALL USER DATA? | PROGRESS |
After data has been loaded,
power will turn off automatically. Please wait for the fan to finish cooling before you turn on the projector again.
OKCANCEL
CHANGE
ENTER EXECUTE
3.Enter the password set for the security password of the
security menu.
• The “INITIALIZE” screen will be displayed.
INITIALIZE
ALL USER DATA
ENTRY SIGNAL
LOGO IMAGE
•ALL USER DATA:
This is for use by service personnel. All setting values including “ENTRY SIGNAL”,
•ENTRY SIGNAL:
All setting values saved for each of the input signals are cleared. To clear just some registered signals, perform the procedure described in “Clearing the data of registered signals”. (p. 44)
•
This returns
•LOGO IMAGE:
The settings for the images registered for LOGO1 and LOGO2 are returned to their factory default images. (p. 74)
4.Press ◄► to select “OK”, and press ENTER.
Note
•If this is executed, the projector enters a standby state in order to reflect the setting values.
Initialize
This returns various setting values to their factory default settings.
1. Press ▲▼ to select “INITIALIZE”.
LOAD ALL USER DATA
INITIALIZE
SERVICE PASSWORD
2.Press ENTER.
•The “SECURITY PASSWORD” screen will be displayed.
SECURITY PASSWORD
4. Press ▲▼ to select the desired initialize item, and press ENTER.
• A confirmation screen will appear.
INITIALIZE | PROGRESS |
OKCANCEL
CHANGE
ENTER SET
5.Press ◄► to select “OK”, and press ENTER.
Service password
This function is used by a service person.