Adjusting the position (continued)
Adjusting the zoom ratio
This adjusts the size of the projected pictures.
1. Press ▲▼ to select “ZOOM”.
| ASPECT | DEFAULT |
|
| |
| ZOOM |
|
|
|
|
| CLOCK PHASE | 0 |
|
|
|
|
|
|
|
|
|
2.Press ENTER.
• The “ZOOM” screen will be displayed.
ZOOM
MODE | INTERNAL |
|
INTERLOCKED | OFF |
|
V | 100% |
|
H | 100% |
|
HV | 100% |
|
|
|
|
3.Press ▲▼ to select “MODE”.
4.Press ◄► to switch “MODE”.
•The setting will change as follows each time ◄► is pressed.
INTERNAL | FULL |
•INTERNAL:
Enlarges the size of the pictures to within the default aspect ratio.
Note
•When “ASPECT” is set to “THROUGH”, “ZOOM” will not appear.
•When other than “DEFAULT” is selected for “ASPECT”, the “MODE” selection setting will not appear.
Clock phase adjustment
Clock phase adjustment achieves the best image when the screen flickers or halos are observed around contours.
1. Press ▲▼ to select “CLOCK PHASE”.
ZOOM
CLOCK PHASE | 0 |
|
|
|
|
|
|
KEYSTONE
2.Press ◄► or ENTER.
•The “CLOCK PHASE” individual adjustment screen will be displayed.
CLOCK PHASE | 0 |
|
|
ADJUST
3.Press ◄► to adjust the level.
•The value changes from 0 to 31. Adjust so that the amount of interference is at a minimum.
•FULL:
Enlarges the pictures using the whole of the display area.
5. Press ▲▼ to select “INTERLOCKED”.
ZOOM
MODE | INTERNAL |
|
INTERLOCKED | OFF |
|
V | 100% |
|
H | 100% |
|
HV | 100% |
|
|
|
|
6.Press ◄► to switch “INTERLOCKED”.
•The setting will change as follows each time ◄► is pressed.
Note
•No optimal value may be obtained if the output of the PC to which the signal input is applied is unstable.
•No optimal value may be obtained if the total number of dots is not correct.
•The clock phase can be adjusted only when RGB signal input is applied with RGB1 and RGB2 IN.
Keystone distortion
correction
Keystone distortion can be corrected only along either horizontal bound of the picture.
OFF | ON |
•OFF :
The “V” and “H” settings are used as the vertical and horizontal zoom ratios respectively.
•ON :
The zoom ratio is set to the “HV” setting. This allows the pictures to be zoomed at equal vertical and horizontal ratios.
1. Press ▲▼ to select “KEYSTONE”.
ZOOM
CLOCK PHASE | 0 |
|
|
|
|
|
|
KEYSTONE
2.Press ENTER.
• The “KEYSTONE” screen will be displayed.
KEYSTONE
KEYSTONE | 0 |
|
|
SUB KEYSTONE | 0 |
|
|
|
|
|
|
