Panasonic PT-DW100U operating instructions Lamp relay, RS-232C setting, Remote2 mode

Projector setup (continued)

Lamp relay

2.Press ENTER.

• The “RS-232C” screen will be displayed.

If using the projector for a continuous period of 24 hours or more, this setting can be used to automatically switch the lamps that are turned on in order to reduce the lamp deterioration that can occur as a result of continuous use.

•“LAMP RELAY” will only be enabled when the lamp selection is “SINGLE” (1 lamp), “DUAL” (2 lamps), “TRIPLE” (3 lamps) or “QUAD” (4 lamps).

1. Press ▲▼ to select “LAMP RELAY”.

LAMP SELECT	QUAD
LAMP RELAY	OFF
RS-232C

2.Press ◄► to switch “LAMP RELAY”.

•The time interval for lamps to be switched will

change as shown in the diagram below each time ◄► is pressed.

OFF 00:00

	(Units of 1 hour)
23:00	01:00

RS-232C

SERIAL IN	RS-232C
(IN) BAUDRATE	9600
(IN) PARITY	NONE
(OUT) BAUDRATE	9600
(OUT) PARITY	NONE
RESPONSE(ID ALL)	ON
GROUP	MASTER
RESPONSE(ID GROUP)	ON

3.	Press ▲▼ to select “SERIAL IN”.
4.	Press ◄► to switch “SERIAL
	IN”.
	• The setting will change as follows each time
	◄► is pressed.
	RS-232C	RS-422
5.	Press ▲▼ to select
	communication conditions.
6.	Press ◄► to confirm the setting.

Note

•The lamps will switch at the specified time when the lamp selection is “SINGLE” or “DUAL”.

•When the lamp selection is “TRIPLE”, the lamps will switch a total of three times at two-hour intervals starting from the specified time, and after this the previous operating status will be maintained until the next specified time is reached.

•When the lamp selection is “QUAD”, three lamps will illuminate from the specified time, and the three lamps will switch a total of four times at two-hour intervals from that time. After this, four lamps will illuminate for eight hours from the specified time, and then when the next specified time is reached, switching between three lamps will resume.

•The setting time will be the local time. (p. 81)

RS-232C setting

This sets communication parameters for the projector. (p. 104)

1. Press ▲▼ to select “RS-232C”.

LAMP RELAY	OFF
RS-232C
REMOTE2 MODE	DEFAULT

7.Press MENU three times.

•The on-screen indications disappear, and the system returns to the normal screen.

Remote2 mode

This sets the REMOTE2 terminal. (p. 108)

1. Press ▲▼ to select “REMOTE2 MODE”.

RS-232C

REMOTE2 MODE DEFAULT

STATUS

2.Press ◄► to switch “REMOTE2 MODE”.

•The setting will change as follows each time ◄► is pressed.

DEFAULT	USER
• DEFAULT:

The pin assignment of the REMOTE2 terminal is used as the projector default setting. (p. 108)

•USER:

This is used for changing an optional input module, using the REMOTE2 terminal, or for changing the settings for the REMOTE2 terminal. Any settings you make for pins 2 to 8 become valid once you press the ENTER button.

78 – ENGLISH