Panasonic R410A Specifications, <CZ-RWSU1U> 4-WayCassette Type U1 Type, controller wires together

<CZ-RWSU1U>

4-Way Cassette Type (U1 Type)

7-5. Indicator Section Installation

Remove the ceiling panel and indicator cover and install the indicator section.

(1) Remove the ceiling panel.

(2) Remove the corner cover behind the mark section. (3 screws)

(3) Remove the mark section inside the ceiling panel. (2 screws)

(4) Install the indicator section in the location where the mark section was attached. (2 screws)

(5) Form the wire to match the panel ribs as shown in Fig. 1-89.

(6) Install the corner cover. (Restrain the wire with the corner cover.)

1 7-6. Operating Controller Installation

CAUTION	Do not twist the operating
	controller wires together
	with the power supply
	wires. Doing so can result
	in malfunction.

If electrical noise is induced in the unit power supply, take appropriate measures, for example installing a noise filter.

Install the operating controller at the indoor unit intake port section.

(1)Fasten the operating controller to the indoor unit intake port section (electrical component box opposite side) with the 2 accessory screws (4×L13/32").

(2)Connect the operating controller 2 wires (WHT, BLK) to the remote control wire (WHT) in the electrical component box. (For details on wiring, see the section “7-9. Electrical wiring” .)

(3)Install the ceiling panel.

(4)Connect the indicator section and the operating controller with the 6P connector (white).

(5)Form the wires with vinyl clamps and fasten.

(6)Connect the ceiling panel wiring connector (2P,

3P) to the body connector in the electrical component box.

(7)For details on test operation, see “Test Run.”

1. Specifications

Air intake grille

Mark section (indicator section)

Ceiling panel

Corner cover

3 screws

Fig. 1-88

Pass the wiring through under the shaft.

Wiring

2 screws

Indicator section

Fig. 1-89

Operating controller

	Electrical
Screws	component box

Fig. 1-90

1-102