Panasonic R410A service manual If Wall mounted Fixed Position, How to Install Batteries

<CZ-RWSC1U>

CAUTION

1. Specifications

If the signal receiving unit is installed near a rapid-start or inverter type fluorescent lamp (neither one uses glow lamps), it may be impossible to receive signals from the wireless remote controller. To avoid signal interference from fluorescent lamps, install the receiving unit at least 6.6 ft. away from the lamps and install at a location where wireless remote controller signals can be received when the fluorescent lamps are on.

7-12. Separate Type Signal Receiving Unit Installation

CAUTION	Do not twist the operating
	controller wires together
	with the power supply
	wires. Doing so can result
	in malfunction.

If electrical noise is induced in the unit power supply, take appropriate measures, for example installing a noise filter.

1 If local electrical codes allow, this signal receving unit can be mounted using a conventional wall box for fl ush mounting.

(1)If Wall mounted Fixed Position

Install the remote controller at a convenient location on a nearby wall. However, before attaching the remote controller mounting cradle, check that the remote controller can operate from the desired wall position. (Fig. 1-97)

How to Install Batteries

See Fig. 1-98.

(1)Press and slide the lid on the back of the remote controller in the direction of the arrow.

(2)Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the battery compartment.

(3)Press the reset hole, then replace the lid. If you press it, the current time, ON time, and OFF time are all reset to 0:00.

	Signal receiving unit
	M4 ⋅ L1"
	Screws (2)		Spacer
	ALL•
	RCU : SUB
	PCB CHK.
	TEST RUN
	RCU : MAIN
	NORMAL
	1 2	3
	ADR
	4 5 6
Notch	Cover plate		Switch box (no cover)
		Fig. 1-96
Fasten the remote control			Fitting the remote
mount with screws.			control in the mount.

2 Press

1 Put in

Remote control mount

Fig. 1-97

Reset hole

Cover

Fig. 1-98

1-106