Panasonic R410A Outdoor unit maintenance remote control, Setting mode 2 <Operating procedure>

(5)

(1) (3)

5. Outdoor unit maintenance remote control

Setting mode 2 <Operating procedure>

(1) Press and hold the button, button, and button simultaneously for 4 seconds or longer.

(2) Use the temperature setting and buttons to change the item code. The item codes and setting data are shown in the table below.

(3) Use the timer time and buttons to change the setting data. To confirm the changed setting data, press the button.

(At this time, “Setting” stops blinking and remains lit.)

(2)

(4) During this mode, “Setting” is displayed, blinking. The display shows the set outdoor unit address “System XX-YY” (System XX = System address, YY =

Address at outdoor unit sub-bus), item code number (DN value in the table below), and the setting data (6 digits).

(The setting data is displayed in 6 digits. The display changes between the first 3 digits (Fig. A ) and the last 3 digits (Fig. B ). When the first 3 digits are displayed, the top point of the colon is lit.)

(5) To end the setting mode, press the button. The display returns to the normal display mode.

A Display of first 3 digits B Display of last 3 digits

(5)

(2)

(1)(3)

80:<Refrigerant type> A and B are displayed alternately. (Example shows 000 410 (R410A).)

5

5-9