Paradyne 9123 manual Setting Up Back-to-Back Operation, Changing Operating Mode

Configuration

Setting Up Back-to-Back Operation

Using this special feature, you can set up two FrameSaver units that are connected back-to-back without frame relay switches between them, as in a test bench setup.

Changing Operating Mode

When setting up back-to-back operation:

HOne unit must be configured for Standard operation, which is the setting for normal operation.

HThe other unit must be configured for Back-to-Back operation so it presents the network side of the UNI (user-network interface).

Only one of the units will have its operating mode changed.

"Procedure

To set up back-to-back operation:

1.On the unit to be configured for Back-to-Back operation, manually configure DLCIs; DLCIs should be configured before connecting the two units.

2.Access the Change Operating Mode screen.

Main Menu → Control → Change Operating Mode

3.Select Back-to-Back Operation, and respond Yes to the Are you sure? prompt.

4.Save the change.

"Procedure

To return the unit to normal operation:

1.Return to the Change Operating Mode screen and switch back to Standard Operation.

2.Respond Yes to the prompt and save the change. The units can be reconnected to a standard frame relay network.

9123-A2-GB20-10 July 2000 3-15