Paradyne 9123 manual Configuring the Physical Interfaces, Configuring the Network Interface

Configuration

Configuring the Physical Interfaces

Characteristics for the following physical interfaces can be configured:

HNetwork Interface

HUser Data Port

Configuring the Network Interface

When configuring the physical characteristics for the network interface, select

Physical from the Network menu (see Table 3-4).

Main Menu → Configuration → Network → Physical

Table 3-4. Network Physical Interface Options (1 of 4)

Line Framing Format

Possible Settings: D4, ESF

Default Setting: ESF

Specifies the framing format for transmitted and received signals on the T1 network interface.

D4 ± Uses D4 framing format.

NOTE: This setting is not recommended by network carriers. False yellow alarms may occur after traffic has been running and the channel returns to idle, or when there is light traffic when other settings are selected. ESF format does not create this problem.

ESF ± Uses Extended Superframe framing format.

Line Coding Format

Possible Settings: AMI, B8ZS

Default Setting: B8ZS

Specifies the line coding format for the network interface.

AMI ± Uses Alternate Mark Inversion (AMI) line coding format.

B8ZS ± Uses Bipolar 8 Zero Substitution (B8ZS) line coding format.

Line Build Out (LBO)

Possible Settings: 0.0, ±7.5, ±15, ±22.5

Default Setting: 0.0

Specifies the line build out for the signal transmitted to the network.

0.0, ±7.5, ±15, ±22.5 ± Specifies line build out in dB.

9123-A2-GB20-10 July 2000 3-23