Paradyne 9123 manual Viewing the Trap Event Log, Troubleshooting Tables, Device Problems

Troubleshooting

Viewing the Trap Event Log

The Trap Event Log displays all traps stored in the SNMP trap event log. ASCII trap strings used to describe trap events are provided in the tables contained in Standards Compliance for SNMP Traps in Appendix B, SNMP MIBs and Traps, and RMON Alarm Defaults.

See Trap Event Log in Chapter 5, Operation and Maintenance, for a screen example and additional information.

Troubleshooting Tables

The unit is designed to provide many years of trouble-free service. However, if a problem occurs, refer to the appropriate table in the following sections for possible solutions.

Device Problems

Table 6-2. Device Problems (1 of 2)

Symptom	Possible Cause	Solutions
No power, or the LEDs	The power cord is not	Check that the power cord is
are not lit.	securely plugged into the	securely attached at both ends.
	wall receptacle to rear
	panel connection.
	The wall receptacle has no	H Check the wall receptacle
	power.	power by plugging in some
		equipment that is known to be
		working.
		H Check the circuit breaker.
		H Verify that your site is not on
		an energy management
		program.
Power-On Self-Test	The unit has detected an	H Reset the unit and try again.
fails. Only Alarm LED	internal hardware failure.	H Contact your service
is on after power-up.
		representative.
		H Return the unit to the factory
		(refer to Warranty, Sales,
		Service, and Training
		Information on page A of this
		document).

9123-A2-GB20-10 July 2000 6-11