CAUTIONS REGARDING HANDLING

Location

Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity.

÷Do not install the unit in a location which is exposed to direct rays of the sun, or near stoves or radiators. Excessive heat can adversely affect the cabinet and internal components. Installation of the unit in a damp or dusty environment may also result in a malfunction or accident. (Avoid installation near cookers etc., where the unit may be exposed to oily smoke, steam or heat.)

÷When the unit is used inside a carrying case or DJ booth, separate it from the walls or other equipment to improve heat radiation.

Condensation

When this unit is brought into a warm room from previously cold surroundings or when the room temperature rises sharply, condensation may form inside, and the unit may not be able to attain its full performance. In cases like this, allow the unit to stand for about an hour or raise the room temperature gradually.

Cleaning the Unit

÷Use a polishing cloth to wipe off dust and dirt.

÷When the surfaces are very dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water and wrung out well, then wipe again with a dry cloth. Do not use furniture wax or cleaners.

÷Never use thinners, benzene, insecticide sprays or other chemicals on or near this unit, since these will corrode the surfaces.

Installing the DJM-3000 in an EIA rack

The screw holes on the front panel of the DJM-3000 are designed for use in attaching the unit to a 19-inch EIA rack.

÷Attach the unit to the rack using screws of the appropriate size (screws not provided with the unit).

Note

÷Never place this unit directly above a power amplifier, as the heat given off by the amplifier might result in damage to the unit. Placing the unit directly above a power amplifier might also result in ham radio signals being picked up or in other types of interference.

÷Always be sure to remove the unit from its rack before shipping.

÷When moving the unit while still installed in its rack, exercise caution to avoid subjecting the unit to shocks or vibration.

AVERTISSEMENTS CONCERNANT L’USAGE

Emplacement

Installez l’appareil dans un endroit bien aéré, où il ne sera pas exposé à de hautes températures ou à l’humidité.

÷N’installez pas l’appareil dans un endroit exposé aux rayons de soleil directs, ni à proximité de poêles ou de radiateurs. Le boîtier et les parties internes peuvent être endommagés par de fortes chaleurs. L’installation de l’appareil dans un environnement humide ou poussiéreux peut entraîner un dysfonctionnement ou un accident. (Evitez d’installer l’appareil à proximité de cuisinières etc., où il pourrait être exposé à des fumées grasses, à des vapeurs ou à la chaleur.)

÷Si l‘appareil est utilisé dans une mallette ou dans une cabine de DJ, éloignez-le des parois ou d‘autres appareils afin de favoriser l‘évacuation de la chaleur.

Condensation

Lorsque cet appareil est déplacé d’un endroit froid vers une pièce chaude, ou si la température de la pièce monte subitement, il se peut qu’il y ait formation de condensation à l’intérieur de l’appareil et qu’il subisse des baisses de performance. Dans ce cas, laissez l’appareil se réchauffer pendant environ une heure ou faites monter progressivement la température de la pièce.

Nettoyer l’appareil

÷Utilisez un chiffon à poussière pour enlever la poussière et les saletés.

÷Si les surfaces sont très sales, nettoyez avec un chiffon doux trempé dans un détergent neutre, dilué dans cinq ou six fois plus d’eau, essorez bien et repassez avec un chiffon sec. N’utilisez pas de cire à meubles ou de détachants.

÷N’utilisez jamais de diluants, de benzène, d’insecticides ou d’autres produits chimiques sur ou à proximité de l’appareil, car ceux-ci abîment les surfaces.

Installation du DJM-3000 dans une baie EIA

Les orifices pour vis du panneau avant du DJM-3000 sont réservés à la fixation de l’appareil dans une baie EIA de 48 cm (19 pouces).

÷Fixer l’appareil à la baie à l’aide de vis de taille appropriée (vis non fournies avec l’appareil).

Remarques

÷Ne placez jamais cet appareil directement au-dessus d’un amplificateur de puissance, car la chaleur qu’il dégage pourrait endommager l’appareil. Celui-ci risque aussi de capter des signaux de radio-amateur ou d’autres types d’interférences.

÷Avant de transporter l’appareil, retirez-le toujours de son armoire.

÷Si vous devez déplacer l’appareil quand il est installé dans son armoire, veillez à éviter les chocs et les vibrations.

6

<DRB1315>

En/Fr

Page 6
Image 6
Pioneer Location, Condensation, Cleaning the Unit, Installing the DJM-3000 in an EIA rack, Emplacement