Pitney Bowes 2-11, Setting Up the W660/W680 Printer, Pitney Bowes W660/W680 Operator Guide

Setting Up the W660/W680 Printer • 2

2.Secure the connector by snapping the two wire clips over the corresponding tabs on the connector, as shown in the figure below.

3.Align the end of the cable connector labelled “Computer” with the printer port on your computer, then push the cable connector into the port. Secure the connection by tightening the screws on either side of the connector.

4.To connect a Serial Cable to the printer, align the 25 pin male connector end of the cable with the serial port on the left side of the printer's interface. Attach the cable to the printer and the computer's hex jack screws using the thumb screws in the connectors.

5.Initialize the W660/W680's communication port by sending data to either the parallel or serial port. When the serial interface is used, the W660/W680 Communica- tions menu settings must be configured to match the computer settings. Configure the computer to use either the XON/XOFF or DTR handshaking settings to commu- nicate with the W660/W680. Use the following sub menus to change the W660/W680 serial communica- tions: A. Baud Rate, B. Parity, C. Word Length and D. Line Termination.

Pitney Bowes W660/W680 Operator Guide 2-11