Pitney Bowes manual Set the Feed Angle, 3 W660/W680 Basics, Setting Up A Job continued

3 • W660/W680 Basics

Setting Up A Job (continued)

3. Set the Feed Angle

The feed angle of the wireframe input stacker depends on the type of material you're running:

•Heavy material—adjust to a low angle

•Standard material—adjust to the center (45 degree angle)

•Light material—adjust to a high angle

To make the adjustment:

1.Loosen the lock knob on the wireframe slide.

2.Move the wireframe up or down as required.

3.Tighten the lock knob to secure the wireframe.

Wire Frame

Lock Knob

3-10 Pitney Bowes W660/W680 Operator Guide