Pitney Bowes manual Setting the Separator Gap, W660/W680 Basics, Setting Up A Job continued

W660/W680 Basics • 3

Setting Up A Job (continued)

5. Lock each separator in place.

NOTE: If the separator gap is not set properly, the printer will misfeed or jam. If the gap is to big, the printer will feed doubles (two or more pieces at the same time). If the gap is too small, material will jam at the feed roller entrance. If you're running post cards and have feeding problems, set a smaller gap between the H-Block separators and feed rollers, or use thinner media.

Setting the Separator Gap

H-Block Separator

Lock Knob

Support Plate

Place a sample piece against the input wall and between the separator fingers and the feed roller

Pitney Bowes W660/W680 Operator Guide 3-7