CHECKING THAT YOUR OVEN IS OPERATING

CORRECTLY

The following simple procedure enables you to check that your oven is working correctly at all times. If you are in doubt, refer to the section entitled “Troubleshooting” on the page 38-41.

The oven must be plugged into an appropriate wall socket. The turntable must be in position in the oven. If a power level other than the maximum (100 % - 900 W) is used, the water takes longer to boil.

Open the oven door by pulling the handle on the right side of the door. Place a glass of water on the turntable. Close the door.

Press the START/+30s button and set the time to 4 or 5 minutes, by pressing the START/+30s button the appropriate number of times.

Result: The oven heats the water for 4 or 5 minutes. The water should then be boiling.

SETTING THE TIME

When power is supplied, “88:88” and then “12:00” is automatically displayed on the display.

Please set the current time. The time can be displayed in either the 24-hour or 12-hour notation. You must set the clock:

•When you first install your microwave oven

•After a power failure

Do not forget to reset the clock when you switch to and from summer and winter time.

1. Press the Multi Function Selector Dial.

2. Turn the Multi Function Selector Dial to set time display type. (12H or 24H)

English - 12

MC28H5135CK_BA_DE68-04441A-00_EN.indd 12

3.Press the Multi Function Selector Dial to complete the setup.

4.Turn the Multi Function Selector Dial to set the hour.

5.Press the Multi Function Selector Dial.

6.Turn the Multi Function Selector Dial to set the minute.

7.When the right time is displayed, press the Multi Function Selector Dial to start the clock.

Result: The time is displayed whenever you are not using the microwave oven.

6/17/2016 12:19:09 PM