SATO 200i manual Error Signals, Mode, Description

Unit 6: Troubleshooting

ERROR SIGNALS

LED	MODE			DESCRIPTION
Red	All modes	Cause:	Low battery charge.
illuminated
		Remedy:	Recharge/ replace battery.
Red		Cause(s):	Bluetooth or Wireless LAN malfunction.
flashing	Online	Remedy:	Replace the interface module.
2.0 seconds
		Cause(s):	1.	Progrom error.
Red	After power On		2.	Flash ROM error.
illuminated		Remedy:	1.	Download program again.
			2.	Replace Flash ROM.
Alternating		Cause(s):	Defective print head.
Green/Red	Online
		Remedy:	Replace print head.
2.0 seconds
		Cause(s):	1.	Cover is not latched or sensor is defective.
			2.	Paper End sensor incorrectly set.
Red flashing	Online		3.	Incorrect media sensor selection or adjustment.
0.5 seconds		Remedy:	1.	Latch cover or replace print head.
			2.	Properly set Paper End sensor.
			3.	Select correct sensor & adjust. Replace bord as required.
Green	Online	Cause(s):	Size of received data exceeds size of receiving buffer.
flashing	(during printing &	Remedy:	Temporarily stop sending data until space is free.
0.5 seconds	data receiving)
Green		Cause(s):	Is in Sleep Mode. Not an error.
flashing	All Modes	Remedy:	Will cease when data is received, a key pressed, or cover opened.
4.0 seconds
Alternating		Cause(s):	Print head is hotter than 70 degrees celsius.
Green/Red	All Modes	Remedy:	Cease printing until the print head has cooled to 50 degrees celsuis
1.0 seconds
			or less.

SATO MB2i Service Manual PN 9001145B Page 6-2