SATO 200i manual 8c, Eye-Mark Sensor Replacement, 8d, Eye-Mark Sensor Replacement

Unit 7: Replacement Procedures

6Insert the replacement eye-mark sensor to the inner cover and route the sensor harness (Figure 7-8c).

Eye-Mark Sensor

Sensor Harness

Figure 7-8c, Eye-Mark Sensor Replacement

7Secure the inner cover to the top housing cover using the two screws (Figure 7-8a).

8Connect the sensor to the circuit board and route the wiring harness (Figure 7-8b).

9Ensure the wiring harness has sufficient slack (Figure 7-8d).

Good

Not Good

Figure 7-8d, Eye-Mark Sensor Replacement

10 Reattach the top, left, and front housing covers.

NOTE: Figure 9-1 of the Charts & Diagrams unit provides guidance on housing cover installation.

SATO MB2i Service Manual PN 9001145B Page 7-11