SECTION 1 - GENERAL INFORMATION
10
1-6 Printer Setup Loading Labels or Tags
ALSO REFER TO THE ACCOMPANYING ILLUSTRATIONS (NEXT PAGE)
1.Lift open the top case.
2.Press the two print head releases toward the rear of the printer to unlock the print head. The print head will pop up slightly. Lift it up until it is fully raised.
3.Remove print media (if any) or empty core from the printer.
4.Unwrap the new media and unwind a few labels from the roll. Labels must be wound
5.Slide the paper guide all the way to the right.
6.Place media roll in the tray so that the media unwinds from the bottom of the roll toward the front of the printer. The label imaging surface must face up as it passes under the print head.
7.Lift the print head and slip the free end of the media under the print head.
8.Adjust the paper guide until the media is snug between the paper guide and the left side of the paper tray.
9.Lower the print head and press it down firmly until it locks closed on both sides.
10.Close the top case.
11.Wait until the Ready Indicator glows green, then press the FEED button to feed a label or to resume printing.
12.If the printer feeds out 7 inches of label and stops and the indicator glows red, recalibrate for the media installed. See calibration.
Rev B
SATO SERVICE MANUAL
CX Series Printers
