SECTION 1 - GENERAL INFORMATION
1-6 Printer Setup
Loading Ribbon (Continued)
TURN RIBBON TAKE-UP
KNOB CLOCKWISE TO
ELIMINATE RIBBON
SLACK
LOWER THE PRINT HEAD
AND PRESS DOWN FIRMLY
ON BOTH HEAD LATCHES
TO LOCK THE PRINT HEAD
IN POSITION
Selecting the Label Sensor Type
CX200 printers support Eye-Mark, gap, or notch label sensing. The printer must be set for the proper sensing method. If you are using label printing software, it should provide a means to set up these parameters. See your software documentation for details. If you are writing your own software or controlling the printer using direct commands, you must use printer commands to set up the print mode and sensing method. Refer to the programming manual.
15
SATO SERVICE MANUAL
CX Series Printers
