SATO CX200 PCA Base Board Removal/Replacement, PCA board removal, PCA board installation, Remove

3-8 PCA Base Board Removal/Replacement

REFER TO THE ACCOMPANYING ILLUSTRATIONS

PCA board removal:

1.Remove the printer chassis according to the instructions in Section 3-4.

2.Remove the module from the main PCA board according to the instructions in Section 3-7.

3.Remove the two Phillips-head screws holding the main PCA board in place.

4.Lift the PCA board gently, then unplug the feed switch connector at J13.

5.Turn the PCA board over and unplug all other connectors.

BACK OF THE

REMOVE (2)

PCA BOARD

PCA board installation:

SCREWS

UNPLUG CONNECTOR

AT J13

UNPLUG ALL

CONNECTORS

44

Reverse the above steps to install the main PCA board.

Rev B

SATO SERVICE MANUAL

CX Series Printers