PowerLogic™ PM5100 series user guide | Chapter |
Setting Up 1-Second Alarms
To set up a standard alarm:
1.Press
2.Press ▼ and ▲to scroll through the list of standard 1– second alarms.
3.Press Edit to select an alarm to be configured.
4.Press Edit to select Pickup Setpoint.
5.Press + to increment the active digit through the numerals
6.Press to enter the selected value for the active digit and move to the next digit to the left.
7.Continue until all values are selected, then press OK to enter the selected number for the pickup setpoint.
8.For power factor alarms (Lead PF, True; Lag PF, True; Lead PF, Disp; and Lag PF, Disp) press ▼to select PU Set Point Lead/Lag, then press Edit. For other alarms, skip to Step 11.
9.Press + and - to scroll between Lead and Lag.
10.Press OK to set the pickup set point lead or lag.
11.Press ▼and follow Steps 4 to 7 for Pickup Time Delay and Dropout Setpoint.
12.For power factor alarms, press ▼to select DO Set Point Lead/Lag and follow Steps 10 and 11. For other alarms, proceed to Step 14.
13.Press ▼and follow Steps 4 to 7 for Dropout Time Delay.
14.Press ▼to select Enable, then press Edit.
15.Press + and - to scroll between Yes and No.
16.Press OK to enable or disable the alarm.
© 2014 Schneider Electric All Rights Reserved | 55 |
