Schneider Electric PM5100 manual Setting up the PM5111, Initializing the meter

PowerLogic™ PM5100 seriesChapter 13—MID Compliance

Lock-protected functions

Menu	Sub-menu		Lock-protected function
	Global Resets	•	Meter Initialization (all)
Resets		•	Energies
	Single Resets	•	Energy

Setting up the PM5111

You must configure all the lock-protected setup parameters before locking the meter.

When the meter is locked, those setup parameters cannot be edited.

Basic setup menu

See “Configuring the basic setup parameters” on page 32 to perform basic setup.

For MID compliance, the Power System must be set to one of the following settings:

•3PH4W Wye Gnd (three-phase 4-wire wye grounded)

•3PH3W Wye Ungnd (three-phase 3-wire wye ungrounded)

Advanced setup menu

See “Advanced setup” on page 38 to perform advanced setup.

You must use ION Setup to edit the device label.

Clock setup menu

See “Setting the clock” on page 37 to change the meter time using the display.

You can also use ION Setup to set or sync the meter time.

Passwords setup menu

See “Setting up the screen passwords” on page 36 to change the meter screen passwords.

Initializing the meter

Initializing the meter clears the meter’s logged data, counters and timers. It is common practice to initialize the meter after its configuration is complete, before adding it to an energy management system.

1.After configuring all the meter setup parameters, navigate through the different meter display screens and make sure the displayed data is valid.

2.See “Meter resets” on page 77 for instructions on clearing the meter’s recorded logged data, counters and timers.

3.Select Meter Initialization to clear all recorded data.

Locking or unlocking the meter

After you initialize the meter, you must lock it in order to conform to MID standards.

1.Navigate to Maint > Setup > Meter >Lock.

2.Press Edit to activate or deactivate the lock.

© 2014 Schneider Electric All Rights Reserved 89